Specifications.
Current consumption:-
Standby
< 0.2mA (< 200uA)
Relay actuation
< 3 Amps
Shutdown
< 12mA
Normal voltage operation range
10 to 16 volts
[031125]
Page 1: ...but it is not recommended to use such high current for several reasons Firstly the whole purpose of SmartGuard is to retain sufficient power in the battery for engine starting All equipment connected to the bypass output will continue to drain the battery For this reason only connect equipment that MUST have a permanent feed A list of MUST have equipment would typically be the radio memory backup ...
Page 2: ...t button to attempt to close the relay unless it was actually SmartGuard that opened it in the first place For this reason it may be found that following installation or trouble shooting for instance if the relay was installed or supplied in the latched open position the relay is latched in the open position and therefore the entire electrical system is shut down It would seem that there is no way...
Page 3: ...Specifications Current consumption Standby 0 2mA 200uA Relay actuation 3 Amps Shutdown 12mA Normal voltage operation range 10 to 16 volts 031125 ...
