2014 Compacta International, Ltd. - Rev.
42014
ZBMPlug15
and Smartenit are trademarks of Compacta International, Ltd.
ZigBee is a registered trademark of the ZigBee Alliance
(949) 429-3303
Technical Support
Smartenit.com
For more information, please visit our Wiki
http://wiki.smartenit.com
Manual (Local) Control
Manual (local) control is done by tapping the Program Button once. Tapping the Program Button toggles the load
between ON and OFF. The Status LED will glow
green
when the load is ON and
red
when the load is OFF.
Program Button Additional Operation
Desired Operation
Action on Pushbutton Device Behavior
Leave Network
Press and hold for 15
seconds
Status LED will begin
fast flashing
Close Join
Press and hold for 3
seconds when device is in
Open Join
Status LED will stop
flashing
Request New Firmware
via OTA
Tap 6 times
LED will quick blip off,
once every second while
OTA update is in progress
Soft Reset
Tap 10 times
LED will go out for about
a second and then device
will rejoin network
Enable for Control4
networks
Press and hold for 10
seconds
Status LED will blink 3
times
Rejoin Network (If
device is in double-
blip LED pattern)
Press and hold for 5
seconds
LED will begin fast
flashing to attempt
network rejoin
Open Permit Join
In addition to extending the range of ZigBee HA devices, the ZBMPlug15 also serves as a router and allows other
ZigBee HA devices to join the network. After the ZBMPlug15 has already joined the network (LED is solid)
proceed as follows:
1.
Press and hold the Program Button for 6 seconds. The Status LED will begin to flash once per second.
The ZBMPlug15 will allow joining of other devices for up to 4 minutes.
2. Join the new ZigBee HA device to the network according to the join method of that device.
3.
When the ZBMPlug15 has timed out for join permission, the Status LED will stop flashing.
4. Permit join can be closed prior to time out by pressing the Program Button for 3 seconds.
Status LED Indication
Color
Indication
Green LED
Load is ON
Red LED
Load is OFF
Pattern
Indication
Fast flashing
Searching for open network
Solid
Joined to network
Short blip
Initiate binding to a controller
Flash once per second
Open Permit Join
Two blips per second
Device cannot find “Parent
Device” and/or network it was
joined to
Rejoin
If the ZBMPlug15 loses power or needs to be moved to a new location, the device will rejoin the network
automatically once power has been restored. The Status LED will flash fast until the device re-establishes
communication with the network, after which the LED will be lit solid.
Monitor and Control Anything from Anywhere!! See our products in action at http://video.Smartenit.com