Longo programmable controller LPC-2.SM7
5.2 Mounting instructions
Figure 3: Housing dimensions
Dimensions in milimeters.
All connections, module attachments and assembling must be done
while module is not connected to the main power supply.
Mounting instructions:
1. Set the correct RS-485 address for LPC-2.SM7 (refer to the table 5).
2. Install the LPC-2.SM7 module on the position which provides maximum effect for its features
with the magnets or screws
2
. Magnets can be pushed to the other side of abutment surface if
needed.
3. Connect interconnection cable to the main module.
LPC-2.SM7 module must be installed properly, isolating any potential connection with electrical
sources other than power supply from main module. Improperly installed module may cause failure
of the module itself, other devices on the same wiring, main module or may lead to fire or personal
injury.
LPC-2.SM7 is connected to the main module with interconnection cable (e.g. SSK, ICM-7). When
more modules are connected to the main module, splitter (e.g. SPL-2) is also required (figure 2).
NOTE
: Signal wires must be installed separately from power and high voltage wires in accordance
with general industry electrical installation standard.
2
Screws are not supplied with sensor.
9
