Longo programmable controller LPC-2.ID1
3.2 Mounting instructions
Figure 3: Housing dimensions
Dimensions in milimeters.
All connections, module attachments and assembling must be done
while module is not connected to the main power supply.
The LPC-2.ID1 module should be positioned on the wall outside the
room. It is advised to avoid direct sunlight or position near
heating/cooling source object. Round flush-mounting box (e.g. Gewiss
GW 24232), Φ60 mm is recommended for installation. A box must be
installed with screw holes in the horizontal position!
Mounting instructions:
1. Mount LPC-2.ID1 module back plate to the provided leveled place on the wall.
2. Fasten 2 screws (DIN 7981 or similar, Φ3 mm,
max. head height 3 mm
) to fix LPC-2.ID1
module to its place.
3. Connect interconnection cable to the interconnection connector K1. Max. allowed tractive
force is 30 N.
4. Power (PWR) green LED should switch on according to the Table 5.
5. Mount LPC-2.ID1 module front plate to the back plate.
IMPORTANT: Front plate must be placed in order that switch S1 (according to the Figure 2) is
pressed (normally is released).
6. Fasten the screw in the bottom carefully (not too strong), to fix the front plate to the back
plate.
5
26
