Welcome to purchase your SMARTECH RC engine powered model car. Please
read this instruction carefully before you starting any work.
Super glue
Driving a radio controlled car is a fascinating hobby which has to be practiced
with the necessary caution and respect. A radio controlled model car which
has a considerable weight and can reach a very high speed can cause damage
and injuries in cause of uncontrolled driving conditions and the user is liable
for this.
Only faultless assembled model will operate and react in the expected
manner. Never improvise with any not suitable aids but use only the original
spare parts if necessary. Even with a prefabricated model you have to control
all connections and check whether they are screwed tightly.
The servo must be set at the center position before installation. To set at a
neutral position, turn on the transmitter and receiver. Set the trim levers in
the center position and turn off the receiver, and then the transmitter. The
servo will be proper neutral position for installation.
Never start driving before you have made sure the followings:
Batteries for transmitter and receiver have a good potential and not weak.
All operable parts are in good condition and you have tested their
operation.
You have made sure that all screws are tightened.
There is no other RC or similar transmitter nearby which could cause
interference.
The terrain where you want to drive isn’t used for common traffic and is
not claimed by any persons or animals.
You transmitter and receiver is switched on and you have checked all
control operations which can be performed.
In case of any porblems concerning your car please contact your local
hobby shop!
We wish you good luck and a lot of fun driving with your SMARTECH
model car.
After each drive all important parts and connectors should be tested. One
simply loosened screw can be sufficient to be lead you model into a
dangerous situation! Attend to your car in regular periods and exchange
defective or worn parts with original spare parts.
Precaution about your engine RC car
Tools needed for assembly
2-channel transmitter system (FM is recommend)
Make sure that you have sufficient insurance coverage in
practicing your hobby.
Battery for
receiver
Engine throttle
servo
Receiver
Receiver
antenna
Switch
Steering
servo
Screwdriver
(big)
Hexagon
wrench
Snips
Needlenose
pliers
Screwdriver
(small)
Hobby knife
Wrech for
wheel nuts
Wrench
Please read the instructions provided with your radio system before using it.
01
Transmitter
Type:301333
Stop
Half forward
Full forward
Battery
cover
Speed control trigger
"AA" battery
or Ni-cd(*8)
Power
switch
Antenna
Steering trimmer
Throttle trimmer
Steering trigger(R)
Steering trigger(L)
Throttle trigger(F)
Throttle trigger(B)
LED of power
Steering control
wheel
REV/TH
REV/ST
Left Right
ON
OFF
