Set Up
25
OFF: Camera does not detect motion.
2) Sensitivity
Set "Sensitivity."
HIGH: It works with even a small change in brightness or motion is detected.
MIDDLE: Intermediate between HIGH and LOW.
LOW: It works only when a large change in brightness or motion is detected.
●
Output Delay Time
1) Set an alarm mode
-OFF: disable the digital output function
-Event: According to the detected result from “Alarm In” and “Motion
Detection”, the event function enables the alarm-out pin which can set
the output delay time in 1, 5, 10, 15, 30 and 60 seconds. This selection
will trigger the alarm-out pin with a high voltage.
-Digital output: According to “DigitalOut.cgi” from SDK, the digital output
function enables the alarm-out pin which can set the output delay time
in 1, 5, 10, 15, 30 and 60 seconds. This selection will trigger the
alarm-out pin with a high voltage. This function is designed for NVR
software manufacturer.
2) Output Delay Time
Set a time to hold alarm output. Choose from 1, 5, 10, 15, 30 and 60 seconds.
This function is used when connecting to alarm output terminals and activating
a siren, buzzer or emergency light.
NOTE
●
Detection sometimes fails if the object is dark.
●
Incorrect detection is sometimes made due to noise if the object is dark and AGC
gain is high. Set the sensitivity to low.
