Electric charging station WBSH2-7
User Manual and data sheet
16
RFID card reader
The WBSH2-7 charging station is equipped with a RIFID card reader that allows you
to start and stop the charging process by using the card.
Emergency button
The charging station is equipped with an emergency button which has the purpose of interrupting the charging in case of
anomalies. At any time, in the event of any emergency, you can press the button and immediately leave the charging
station.
Note:
In case of anomalies with the device, make sure you have pressed the emergency button and immediately contact
our customer support by visiting the site:
http://helpdesk.smartdhome.com/users/register.aspx
Charging socket and side support
The device is equipped with a type 2 charging socket. When the charging station is in standby it is recommended to place
the charging socket in the appropriate side support in order to protect it from falls and any accidental damage.
Configuration
Note:
The WBSH2-7 charging station can be configured using a laptop or smartphone connected to the Internet. For a
correct configuration follow all the steps below.
•
Put the laptop/smartphone in Wi-Fi search mode. Subsequently, the charging station will set itself up in Wi-Fi
access point mode, allowing access to the configuration of the parameters.
•
Connect your laptop/smartphone to the Wi-Fi signal transmitted by the charging station
Note:
The association to the Wi-Fi network does not require a password to connect to the charging station. If the
network transmitted by the charging station is not transmitted, it is recommended to restart the device.
•
Start the browser and enter the address 192.168.4.1 in the address bar, then you will have access to the
configuration.
Note:
Do not Google the address, otherwise the procedure will fail.
