MyMB interface/actuator for ModBus systems
User manual and data sheet
Rev. 3 del 02.12.2022
Pag. 9/18
Wi-Fi setup
ATTENTION!
Although the device has multiple communication modes, they cannot be configured at the same
time. Before configuring the device, carefully choose the desired type of communication.
ATTENTION!!! If you have an active license to use the Contact Pro IoT platform, you can carry out the
following procedure (choice 1). If you do not have an active license and need to use the IoB app, you
must contact your sales representative in order to proceed with the purchase of a new license.
Otherwise you can proceed with the configuration by following the procedure below (choice 2).
Wi-Fi configuration with App (choice 1)
For a correct configuration of the device, it is necessary to download and install
the IoB application on your smartphone. Then set the MyMB in programming
mode, turning on the device and pressing the
function
key for about 3 seconds.
When the button is released, the device will enter configuration signaling the
status with an alternate flashing of the LEDs (red and green). This will create
the "IoB" Wi-Fi to which you will need to connect to proceed with the
configuration.
At this point it is necessary to open the application installed at the beginning.
Once inside, press
Set up Remote Server/Wi-Fi
on the Home screen (see
image on the left) and click on continue in the pop-up that will appear.
On the page that will open, move to the Wi-Fi section (see image). Then press
the key to view the list of Wi-Fi detected by the device. Select the correct
one, enter the password and press
SAVE
. If the Wi-Fis are not present or visible,
press the reload button on the list.
The operation was successful, a message of successful configuration will be
visible at the bottom of the screen.
To end the process, press the Close button at the top right. The LEDs on the
MyMB device will stop flashing alternately.
At the end of the programming procedure, the device will be operational again
with the new configuration. In case of unsuccessful programming, or to cancel
it, press the
RESET
key and the device will restart.
