MyOT interface/actuator for OpenTherm Boilers
User manual and data sheet
7
On the page that opens, move to the Wi-Fi section (see image).
Then press the key to view the list of Wi-Fi detected by the device. Select the
correct one, enter the password and press
SAVE
. If the Wi-Fi is not present or
visible, press the reload button in the list.
The operation was successful, a successful configuration message will be visible
at the bottom of the screen.
To end the process press the
Close
button at the top right. The LEDs on the MyOT
device will stop flashing alternately.
At the end of the programming procedure, the device will be operational again with the new configuration. In case of missing
programming, or to cancel it, press the
RESET
key and the device will restart.
Wi-Fi configuration without application (not recommended)
WARNING!
Any type of intervention by our technicians, which will be caused by an incorrectly performed installation or
by a failure caused by the customer, will be quoted and will be charged to those who purchased the system.
If you have good experience with this type of device, you can configure MyOT without using the application:
1.
Switch on the device.
2.
Press the
FUNCTIONS
button for 3 seconds.
3.
Release the button and verify that the device is in configuration mode. The LEDs will flash alternately (red and
green).
4.
Connect your smartphone at the Wi-Fi network with SSID IoB (no password).
5.
Once the connection has been established, open the navigation application and enter the following link and
press enter:
http://192.168.4.1/sethost?host=iobgw.contactproready.it&port=9577
A white screen with the inscription OK will be displayed.
6.
Open the browser and enter the following second link:
http://192.168.4.1/setwifi?ssid=nomerete&pwd=passwordwifi
Insert instead of
nomerete
the SSID of the network you want to connect to. Enter instead of
passwordwifi
the
Key of the Wi-Fi chosen.
A white screen with the inscription OK will be displayed.
