AIR
AIR
Discard of the cleaning powder
( Refer to the Operation Manual 7-1~7-2 )
• Cleaning of smartGun PERIO after use and regular maintenance are required.
( Failure to do so may cause powder blockage, water leakage, etc. )
• The Nozzle Tip is a single use product. Do not reuse or resterilize it.
• If powder remains in the Powder Case or Handpiece, it will solidify which may cause clogging.
• Before use, thoroughly dry the coupling, handpiece, hose joint section of the powder case, inside of the powder case, and
nozzle. Also, perform idle running with air alone to expel any internal water.
• Make sure you clean the smartGun PERIO in an ultrasonic bath once a week to prevent the instrument from clogging ( refer to
the Operation Manual 8-1 ).
Caution
1
2
After removing the
cleaning powder in
the powder case,
perform idle running
with air alone to
discharge water
and powder in the
nozzle.
Blow off the powder
remaining in the
powder case with air.
Fit the supplied
blower nozzle to
the coupling and
attach to the
handpiece. Run idle
with no water for
more than 5 sec. to
clear lines.
Use the blower
nozzle in the same
way to clear the lines
in the smartGun
PERIO nozzle. Blow
from the far end of
the nozzle.
1
3
2
Ultrasonic cleaning
( Refer to the Operation Manual 8-1 )
Be sure to do this once a week or after operating Troubleshooting.
Sterilization
( Refer to the Operation Manual 8-2 )
Dry the O-ring section
of the powder case
and the Adjustment
Ring section, apply a
drop of the supplied
turbine oil and rub it
in with your fingers
( refer to the Operation
Manual 7-4 ).
Carefully clean the
inside of the joint
section of the
handpiece and the
O-ring section of
the powder case
with the supplied
cleaning brush.
If powder adheres
to the O-ring
section, remove the
O-rings, and
carefully clean the
O-rings and
grooves.
Remove the rubber
packing and
disassemble the
powder case cap.
Rinse under
running water.
Perform ultrasonic
cleaning with hot
water ( refer to
the Operation
Manual 8-1).
Disassemble the powder case cap and rinse under
running water.
All the parts are autoclavable. Perform autoclave
sterilization up to 135˚C after cleaning.
ex.) Autoclave for 20 min. at 121˚C, or 15 min. at 132˚C,
or 3 min. at 134˚C.
※
In case the sterilizer chamber temperature may exceed
135˚C during the drying cycle, skip the drying cycle.
※
Blower nozzles for other brands couplings
are also available.
If you fail to lubricate the O-ring section, the powder case and
handpiece may no longer swivel freely and water may leak.
Be sure to remove the cleaning powder and clean it prior to ultrasonic cleaning.
Rubber packing
Care After Use
Handpiece
Blower nozzle
Blower nozzle
Nozzle
Coupling
When idling, hold the
Nozzle and Handpiece
tight.
1
Cleaning
( Refer to the Operation Manual 7-3~7-4 )
2
3
3
4
AIR
