2
Connect Finger-touch sensor and locks to the electronic controller. If you do not intend to utilize
all lock ports leave the spare connectors plugged in to the controller to protect the pin ports from
damage and dust.
Make sure everything is properly connected before plugging in the power adapter to an outlet.
The Finger-touch sensor must be connected to the electronic controller prior to
connecting the power adapter to an outlet.
Verifying Power
A blue light will shine from the electronic controller case immediately after power is applied from
the power supply. 8 seconds later the finger-touch sensor will quickly flash purple, indicating the
system is operating normally.
Note: The finger-touch sensor is required to do a full password reset so it is
recommended to store at least two fingerprints during the initial setup. For security
reasons only the first three fingerprints recorded have access to do a password reset.
