System controls
These commands enable you to switch system settings and access system information.
These commands inform you of the current system settings. These commands are unavailable when
the projector is in Standby mode.
Command
Response
get autosignal
autosignal=[current auto signal detection setting]
get lampreminder
lampreminder=[current lamp reminder setting]
get highbrightness
highbrightness=[current lamp brightness setting]
get autopoweroff
autopoweroff=[current auto power off setting]
get zoom
zoom=[current zoom setting]
get projectorid
projectorid=[current projector ID number]
get hposition
hposition=[current horizontal position offset setting]
get vposition
vposition=[current vertical position offset setting]
get aspectratio
aspectratio=[current projector aspect ratio]
get projectionmode
projectionmode=[current projection mode]
get startupscreen
startupscreen=[current startup screen setting]
get resolution
resolution=[current input resolution]
get language
language=[current language setting]
get groupname
groupname=[current projector group name]
get projectorname
projectorname=[current projector name]
get locationinfo
locationinfo=[current projector location]
get contactinfo
contactinfo=[current support contact information]
get modelnum
modelnum=[current model number]
get videomute
videomute=[current video mute setting]
get serialnum
serialnum=[serial number]
A P P E N D I X
B
Remotely managing your system through an RS-232 serial interface
77
