2 / 3
p/n 483933 Rev. 3/12
LSI Industries Inc. 10000 Alliance Road Cincinnati, Ohio 45242 (513) 793-3200 Fax (513) 793-0147 www.lsi-industries.com
©2012 LSI Industries Inc.
483933 Rev. 3/12
1 / 3
LSI Industries Inc. 10000 Alliance Road Cincinnati, Ohio 45242 (513) 793-3200 Fax (513) 793-0147 www.lsi-industries.com
INSTALLATION AND ASSEMBLY INSTRUCTIONS
Crossover® XCHM3 LED Area Luminaire
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
BEFORE YOU BEGIN
Read these instructions completely and carefully, observing all CAUTIONS and
WARNINGS shown throughout these instructions.
WARNING! RISK OF ELECTRIC SHOCK
· Disconnect or turn off power before installation or servicing.
· Verify that supply voltage is correct by comparing it with the luminaire label information.
· Make all electrical and grounded connections in accordance with the National Electrical Code (NEC) and any
applicable local code requirements.
CAUTION: RISK OF INJURY
· Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or performing
maintenance.
· Allow lamp/luminaire/driver to cool before handling.
NOTICE: RISK OF PRODUCT DAMAGE- Failure to follow instructions could result in damage to product
and void ALL warranties!
· Only install fixture with lens facing downward.
· Never connect components under load.
· Do NOT mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.
· Do NOT exceed fixtures maximum ambient temperature rating.
CLEANING INSTRUCTIONS
· It will occasionally be necessary to clean the outside of the lens. Frequency of cleaning will depend on
ambient dirt level and minimum light output which is acceptable to the user.
· Lens should be wiped with a DAMP cloth with a solution of warm water and a mild, non-abrasive household
detergent. Dry with soft, dry, clean cloth.
· Do NOT use chemical cleaners such as powder cleansers, bleach, etc.
· Do NOT use scouring pads, as this will scratch and damage the lens finish.
· Do NOT wipe with a soiled cloth or wet towel - these may leave a residue that can damage finish.
· Do NOT pressure wash or hose down luminaire.
Crossover® XCHM3 LED, cont'd.
ALL UNITS:
1. Remove luminaire from packaging, taking care to protect lens and finish. Check packing slip to make sure all
parts are present before proceeding. Check carton for supplied mounting hardware.
2. Place luminaire on its back, lens-up, on protected surface. Open door by loosening (2) screws.
IMPORTANT! Type FT and FTA reflector models have arrows imprinted on reflector (look thru lens). See
below for certain reflector types and how they mount to pole with specific light output! Reference luminaire
layout.
3. Lay pole on raised surface. Protect pole finish with soft cloth.
4. From hardware kit, install nut plate into pole end, so the large center hole is closest to pole end. Thread both
all-thread rods into nutplate. See Figure 1.
5. Feed supply wiring thru center of arm. Slide arm over all-thread.
Figure 1
Listed for Wet
Locations
Type 5
(light beams
all directions)
Type FT and FTA
(note light beam
arrow in center)
