6.2 Angle Mode Setup
Sometimes, you could need to position the monitor to weird angle and you want that the
system will maintain that position regardless of the inclination of the sled.
To achieve this, just press the command button
three
times. After that, the system will alert
you to be entered in "Angle Mode Setup" with a low pitch beep and with a low speed
blinking of the multi-function button.
At this point, just roll the monitor to the desired position within 2 seconds and maintain it in
that position until the Horizon will emit a new acoustic feedback.
The multifunction button will stop blinking and the Horizon will maintain that angle as
"predefined" one.
Please note that the new angle is considered by the
Horizon, the new “predefined” one. Even a complete Power
Cycle or a Motor Toggle ON/OFF will not cancel this new
setup.
To re-establish the default Horizontal Mode just read the
paragraph 6.3
VISUAL RECAP FOR ANGLE MODE SETUP
User Interaction
PUSH BUTTON
THREE
TIMES
Horizon Acoustic Answer
QUICK BEEP AT EVERY BUTTON PUSH
Horizon Command Execution
LOW PITCH LONG BEEP, MOTOR
DISABLE, LOW FREQUENCY BLINK
User Interaction Required
ROLL THE MONITOR TO THE DESIDERED
POSITION WITHIN 2 SECONDS
Horizon Command Execution
LOW PITCH SHORT BEEP, MOTOR
ENABLE, STOP BLINKING LED, NEW
ANGLE CORRECTLY SETUP
19
Summary of Contents for SMARTCAM HORIZON
Page 1: ...1 v 1 2 ...
Page 5: ...4 SmartCAM Horizon Overview 5 ...
