User Guide
P.5
1-way companion remote (where available)
LOCK:
Locks the doors and arms the STARTER
KILL (if installed).
UNLOCK:
Unlocks the doors and disarms the
STARTER KILL (if installed). Activates the
AUX 1
output if Priority Door Access is configured.
TRUNK:
Opens the
TRUNK
or activates the
AUX 3
output.
Note:
Trunk option must be installed.
START/STOP:
Remote starts or stops the engine.
Gets the system into Cold Weather mode by
pressing the
SHIFT
button and then pressing and
holding the
START/STOP
button for 3 seconds.
Note:
Icon may vary.
AUX
AUX (upper right side):
This button serves as a
second function button.
This button allows assigning different functions to
any of the other four buttons.
Vehicle Presets
Heater
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, should not be left on
HIGH
. It
is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain
types of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in
a dead battery.
P.16 User
Guide
Vehicle Status Request
The status request feature allows the user to see the status of the vehicle
i.e.: if the doors are
locked or unlocked or if the vehicle is in cold weather mode, home valet mode, in valet mode or
how much time is left in the run time cycle. The following charts (Tables 1, 2 and 3) indicate the
confirmation sequences.
To retrieve the vehicle status:
Press and release the
AUX
button
then press and release the
button (there will be a beep).
The transmitter will then flash the corresponding sequence of LED’s depending on the vehicle’s
status.
x
If the engine is NOT running
x
If the vehicle is in or out of ready mode
x
If the engine IS running under a remote start (if the doors are locked)
or (if the doors are unlocked).
The status request feature is a two-step procedure:
x
The first sequence of flashes denotes if the vehicle’s doors are locked or unlocked.
x
The second sequence of flashes (if applicable) denotes if the vehicle is Cold Weather mode,
Home valet mode, or, Valet mode.
x
If there is no second sequence transmission, then the vehicle is none of the 3 mentioned
features (Cold weather mode, Home valet mode or Valet mode).
Status Request When the Engine IS NOT Running
STATUS
SEQUENCE
LOCK
UNLOCK
TRUNK
START/STOP
Beep(s)
Lock
3 flashes
1
Unlock
3 flashes
2
Cold
Weather
1
st
sequence
if locked
3 flashes
2
1
st
sequence
if unlocked
3
flashes
2
2
nd
sequence
1 second
Home
Valet
1
st
sequence
if locked
3 flashes
2
1
st
sequence
if unlocked
3
flashes
2
2
nd
sequence
1 second
1 second
Valet
Mode
1
st
sequence
if locked
3 flashes
1
1
st
sequence
if unlocked
3
flashes
1
2
nd
sequence
1 second
1 second
