3
|
INSTALLING YOUR SMART BOARD 685IX PREMIUM INTERACTIVE
WHITEBOARD SYSTEM (APPLIANCE-BASED)
Mounting your SMART Board 685ix
interactive whiteboard system on a
FUWM-600 wall mount
Important
Before mounting your interactive whiteboard system on the FUWM-600 wall mount,
carefully read and observe the following instructions for operating safety and to avoid
damage to your product.
WARNINGS
•
Failure to follow these instructions could result in personal injury and product
damage.
•
Two people are required to safely mount your UX60 projector and interactive
whiteboard on the wall mount because they could be too heavy for one
person to safely maneuver alone. When you lift your interactive whiteboard,
you and your assistant should stand on either side of the screen, supporting
its weight at the bottom corners while balancing the top with your other hands.
•
Do not leave cables on the floor where they can be a tripping hazard. If you
must run a cable over the floor, lay it in a flat, straight line and secure it to the
floor with tape or a cable management strip of a contrasting color. Handle
cables carefully and avoid excessive bending.
Tools required
To mount your interactive whiteboard on the FUWM-600 wall mount, you need the
following tools, which aren’t included:
•
a Phillips® No. 2 screwdriver (all screws must be tightened by hand)
•
a stepladder
CAUTIONS
•
If you need to lean your interactive whiteboard against a wall before you
mount it, make sure that it remains in an upright position, resting on its pen
tray brackets, which are designed to sustain your interactive whiteboard’s
weight.
•
Do not rest your interactive whiteboard on its side or on the top of its frame.