13 |
INSTALLING YOUR SMART BOARD 685IX PREMIUM INTERACTIVE
WHITEBOARD SYSTEM (APPLIANCE-BASED)
Installing the control module
After you connect all of the cables, you can install the control module into the pen tray.
To install the control
module
1. From the bottom of the pen tray, bend the
expansion slot cover’s three plastic tabs toward
the center of the cover, and then push it up to
remove it.
2. Place the control module into the pen tray’s
expansion slot and gently push down until it
snaps into place.
Installing the pen tray
To install the pen tray
1. Position the pen tray in line with the two
L-shaped metal brackets, and then slide it
toward the wall until it’s firmly against the
bottom frame of your interactive whiteboard.
The pen tray clicks into place.
2. Route the control module’s modular I²C cable
under the lower-right end of the pen tray and
insert it into connector
1
.
3. Press the cable into the strain relief channel on
the bottom of the tray.
This step protects the modular cable’s RJ11
connector from damage if the pen tray is
removed when the cable is still connected.