SMART-AVI HDR-UltraS, User Manual

Page: 7 / 12

7
Debug mode is a more user-friendly way of operating the HDR-ULTRA and it
also includes instructional menus. To enter the Debug Mode, type in “d on”
followed by <ENTER>.
Below are the Debug Mode Menu Items:
===========================================================================
Command Line Interface Help:
d
Enable/Disable debug d [on][off]
sw Switch Port sw [output] 1-16 [input] 1-16
br Broadcast Port br [input | / | \] 1-16
om Set output mode om [output] [mode# (0-2) | ?]
o Enable/Disable Output o [output] [0 = disable | 1 = enable]
to Toggle Output Enables to
q Query Crosspoints
h Toggle Hotplug h [input]
olev Set Output level olev [output | ? | r | a] [level (1-10)]
edid Manage EDID
reset Restore Factory Settings
boot
Reboot matrix
info Display matrix info
help Command list
?
===========================================================================
Learning the EDID of the Monitor Using Debug Mode
1. Connect CAT5e/6 cable from one of the HDX-Ultra Receivers to the
OUT1 of the HDR-ULTRA.
2. Connect a straight-through male-to-female RS-232 cable from the com-
puter to the RS-232 port of the HDR-ULTRA.
3. Run HyperTerminal on your PC (or use the terminal client of your
choice).
4.
Cycle the power of the HDMI (reset) and you should see the following
on the screen:
SmartAVI HDMI 16X16 ver 12.06.11#1
5.
To enter the Debug Mode type “d on” and hit ENTER. You will see the
following prompt:
DBG>
6.
Type in “edid” and hit ENTER to go to Manage EDID:
EDID>
7.
Type in “learn” and hit ENTER to learn the monitor plugged in port 1:
EDID> learn
Successfully learned EDID!
Note: EDID learning is also available using front-panel selection.