Bar
10
Bar
9
Bar
8
Bar
7
Bar
6
Bar
5
Bar
4
Bar
3
Bar
2
Bar
1
9
10
11. Scooter & battery Maintenance
10. How to install mojo?
Basic troubleshooting
Keep the scooter and its battery in a dry environment with optimal temperature
when not in use. Do not leave the scooter in the rain, freezing cold or under the
sun in a middle of a sunny day. Keep the battery dry. Negative environmental
conditions can damage the battery. Swipe it out by a cleaning rag after every
use. Do not need to take the battery out when not in use. Always keep the
battery charged to avoid totally depleting it before charging, which can help a lot
to prolong its life.
The battery needs to be charged or there is a bad connection of the
battery. Check the connection of the battery. If the connections are good,
try to charge the battery.
There is a bad connection of the motor. Check all connection between
the motor and the controller.
The motor has a short circuit of a battery connection. Contact your
service agent.
Not used.
Not used.
The S-Drive can’t be driven, which may be because the battery charger is
connected or the seat is not in the driving position.
Joystick is out of order. Make sure the joystick is in the parking position
before switching on the scooter power.
A controller fault is indicated. Make sure that all connections are secure.
The parking brakes have a bad connection. Check the parking brake and
motor connection. Make sure the controller connections are secure.
An excessive voltage has been applied to the controller, which is usually
due to a battery connection problem. Check battery connection.
Attention:
1. All sound is based on the buzzer from the scooter. (One light on the screen
represents one sound from the scooter.)
2. If it doesn't work itself out, please contact the local distributor for judgment
and repair to avoid secondary damage to the scooter.
rear axle wrench
rear axle group
seat, main part of the scooter
1
1
2
2
3
3
1. Pull up the rear axle wrench until the
anti wheel touches the ground.
2. Lift up the seat at a 45-degree angle.
3. Push the rear axle group closer to
the seat and hitch them together.
4. Press down the rear axle wrench
and lay down the seat.
5. Done!
