SMAR HART FY500, Installation Operation & Maintenance

Page: 3 / 64

FY500 HART – Operation, Maintenance, and Installation Manual
III
GENERAL
This operation and maintenance instruction manual provides installation, operating, calibration, and
maintenance information for the FY500.
The FY500 must only be installed, operated, and maintained by qualified personnel with fully trained
in field equipment installation.
For additional assistance or if there is any question concerning the instructions, contact SMAR.
Modifying this product, substituting non-factory parts, or using maintenance procedures other than
outlined could drastically affect performance and be hazardous to personnel and equipment, and
may void existing warranties.
NOTE
This manual is compatible with version 1.XX, where 1 indicates software version and XX
software release. The indication 1.XX means that this manual is compatible with any release of
software version 1.
SAFETY TERMS
To avoid personal injury or property damage, WARNING and CAUTION notes must be strictly
followed. Always follow the standard industry safety practices and cautions when working on this or
any process control product.
Refer to the appropriate instruction for hazardous area.
WARNING
Throughout the operation of the positioner, including self setup, do not touch the moving parts of
the valve/actuator/positioner set as they may unexpectedly move.
Do not remove FY500 from the valve while the valve is still pressurized. Make sure to disconnect
the electric power, control signal, or air supply before touching any moving parts.
Check with the process or safety engineer for any additional measures that must be taken to
protect the process
.
UNPACKING AND STORAGE
Although Smar takes steps to prevent damage in transport, such damage is possible and must be
discovered and reported before installing the FY500. Do not install the positioner that has been
damaged in transport or during storage.