Section 1 - Installation
1.5
Figure 1.4
– Positioner assembly orientation relative to actuator axis
6. Fit the rotary adaptor onto the feedback shaft of the FY500 and adjust its position on the actuator
shaft so that the arrow on the actuator lines up with the arrow mark on the back of the FY500
housing. See figure 1.5.
7. Attach the rotary adaptor to the feedback shaft with one M6 x 10 screw, as shown in figure 1.5.
Tighten until the screw fully enters the part.
Figure 1.5
– Rotary adaptor assembly orientation on actuator
8. Install the L-shaped parts of the mounting bracket to the FY500, using M6 screws, if not already
in place.
9. Install the mounting bracket on the actuator with four M5 x 0.8 screws and flat washers. See
figure 1.6. When attaching the FY500 rotary adaptor to the actuator shaft, ensure that the center pin
Summary of Contents for HART FY500
