Gas & Water Monitor Installation Manual
Page 13 of 18
Installing your Smappee Gas & Water Monitor
Overview
The installation of the Smappee Gas and Water will always be done over a Bluetooth connection.
In this section, you will find the different steps of the installation and a guideline to help with the
most common pitfalls or installation difficulties.
Starting the installation
To start the installation of your Smappee Gas & Water Monitor, please go to the App and select
screen where you can add a new Smappee Gas and Water Monitor.
From now on, please follow the instructions in the app.
Note: If you wish to change the settings of your sensors or the configuration of the leak alerts
Steps of installation
The installation consists of the following steps:
1. Connecting with Bluetooth
2. Selecting the sensor (optical or magnetic)
3. Calibrating the red line (only with Optical Sensor)
4. Setting the decimals, pulses and unit
5. Saving the configuration to your Smappee
6. Choosing the Communication Method (RF or Bluetooth)
7. Configuring the Leak Detection