5
Elevator Control Horn Installation
•
Using Epoxy glue, glue the control horn
into the two 1/16
th
inch holes on the
bottom of the horizontal stabilizer
o
Secure by gluing the retainer on
the other side. The magnet to
retain the stabilizer to the fuselage
is already installed for you.
Windshield Installation
•
Remove backing from vinyl windshield
•
Apply vinyl windshield to fuselage
•
Press windshield sides around fuselage
and press firmly
Servo Installation
•
Feed servo wire from servo slot through fuselage and into radio compartment
•
Press servo into servo holes by rocking the
servo gently until seated. Be carful not to
crush the foam on either side when
starting servo into hole. The servo's install
with the wires facing front of fuselage.
Control Rod Installation
•
Connect your receiver up to the ESC
(Electronic Speed Control) and two
servo’s.
o
The top servo is for rudder and the
bottom is for elevator
o
Connect your battery pack to the ESC
o
Test that your radio is functioning and allow servo’s to center
