2
FAUCET ROUGH-IN
Install faucet with o-ring into the center hole in deck or lavatory –
1-5/16” (33 mm) minimum hole required.
NOTE:
if installing the faucet on a three (3) hole sink, a trim plate should
be installed at this time.
Remove nut, faucet
retainer and gasket.
DO NOT
remove the
o-ring from base of
faucet.
DO NOT
remove sensor
label until step.4
A
B
1 - INSTALL FAUCET
EAF-350
1.5 gpm (5.6 Lpm) Max. Flow or
0.5 gpm (1.9 Lpm) Max. Flow
Faucets with Single Line Water Supply
EAF-350-ISM
1.5 gpm (5.6 Lpm) Max. Flow or
0.5 gpm (1.9 Lpm) Max. Flow
Faucets with Hot/Cold Water Supply
4-3/64”
103 mm
4-3/64”
103 mm
5-5/32”
131 mm
1-5/16”
33.5 mm
Min. Hole Required
Spout
O-ring
13”
330 mm
Long Flex Hose
If a connection to separate hot and cold
water supplies is desired, then a
Bak-Chek
®
tee fitting or BDM or BDT
(not supplied) must be used prior to
connecting to the faucet.
Tempered
Supply
Nut
Retainer
Gasket
1 ¾”
45 mm
Max. Deck
Thickness
1-5/16”
33.5 mm
Min. Hole Required
Spout
O-ring
13”
330 mm
Long Flex
Hoses
Hot
Supply
Nut
Retainer
Gasket
1 ¾”
45 mm
Max. Deck
Thickness
Mixing Lever
(Can be set and
removed)
Cold
Supply
1-5/16”
33.5 mm
13-49/64”
350 mm
9/16”
UNEF
Max.
1-49/64”
45 mm
5-5/32”
131 mm
2-1/8”
54 mm
Front View
O-RING –
DO NOT REMOVE
FAUCET
GASKET
FAUCET
RETAINER
NUT
Remove
before use
FAUCET
CENTER HOLE IN
DECK OR LAVATORY
O-RING
Remove
before use
Front View
Side View
