18. Locate the elevators and the hinges to glue in the elevators onto the horizontal
stabilizers. Glue it in using the same method as was used in the rudder installation
above.
19. Locate the control horns for the elevators and prepare for installation. See pictures
below for the locations for the control horn. You will need two servos on either side of
the fuselage.
Tip
: Measure both sides of the elevators and drill a small pilot hole. Once it is squared
use a right drill bit and drill trough. You can use a countersunk bit on the top of the
elevators to provide a cleaner look. Once the hole is made, wick it with thin CA to
harden it.
