V 1.10 11/14/2018
7
•
Flip the wing over, install the aileron servo
extension cable and then add sheeting as was
done on the top side. The plywood end cap
rib is added, and the leading edge is sanded
round. After a final sanding to level out any
uneven joins, the wing is now ready to cover.
•
Laminate all the parts together for the servo
doors/mounts. This is a good time to
program your radio and set up the servo
travel. Install the servo arm and mount the
servo on the door/mount.
•
Aileron ribs are added to the bottom pre-cut
sheeting using the laser etched lines as a
guide. Add the 1/8” balsa leading edge piece
and sand it to the taper of the ribs. Add the
top sheeting and final sand the ailrons.
•
The ailerons are top hinged using two strips
of covering material (one on top side and one
on the under side) to make the hinge
.
