V 1.10 11/14/2018
11
•
Install the elevator servo arm and screw it to the servo mount plate. (again, this is a good
time to program your transmitter and to set the servo travel for the elevator servos). Do not
use the rubber grommets, hard mount the servo directly to the plywood plate.
•
Recommended elevator servo is Spektrum A7020 thin wing servo. Use the supplied long
double arm with one side removed. Pull the servo leads through the ribs and out through
the holes in the bottom skins. No extension is needed.
•
Add the balsa “donut” pieces to the inside
of the TE to extend the holes for the hinge
points. Sand the stab spar joiner to fit
between the top and bottom spars. Then,
add the top spar. Break off the build leveling
tabs and sand the TE and ribs to contour.
Add the top skins, trim off excess, and sand
leading edge round. Add Stab tips and final
sand the stab.