Page
6
of
21
CHANGING TO “LOCKED” MODE
1.
To change your SlingStick from the “POWER RESPONSE” mode to the “LOCKED MODE” locate the
included Detent Pin.
Locate the locking hole in the black outside tube of the SlingStick which is 9” from
the bottom of that tube. Stand over the SlingStick and wedge it in underneath your arm, pinching it in
between your arm and body and gripping it with that hand. Slowly bend over compressing the outside
tube down over the inside tube, watching the locking hole as you do this. Hold the Detent Pin with your
free hand and once you see the locking hole aligned in the inside tube through the outside tube push
the Detent Pin in
to it. Those holes will align when the outside tube has compressed down to expose 1’
of the inside tube. Push the Detent Pin completely through the SlingStick so that ball in the Pin has
fully emerged through the far side.
2. You may use the Velcro tie on the Detent Pin to secure the Pin ring so that it does not rattle during use.
To do so secure it to the SlingStick as shown here.
