Important !
This interface will only work with Side-Power thrusters with a S-link
control system.
Installation:
1. Connect the (foot)switches according to the wiring diagram(s).
2. To connect the optional radio remote, first cut the wires close to the plastic
connector on the “bow” connection lead according to Fig. 1. Strip the wires
properly and connect to the 8730 according to the wiring diagram(s).
Do the same with the “stern” wires if needed.
3. Mount the 8730 in a place where it will be protected from direct and con-
ensed water ingress. Use cable ties or other suitable means of mounting.
4. Plug the S-link Spur cable into the green connector at the rear of interface
box. Twist the locking ring on the connector clockwise to secure connector.
Installation guide S-link external switch interface 8730 Page 2
The 8730 external switch interface allows the use of mechanical foot switches
or other normally open switches to control a S-link bow thruster. In addition it
allows for connecting the 8980/8985 radio remote control.
The 8730 sends proportional thrust on the S-link bus. This is 70% as default.
This value can be changed on an PJC212, PJC211, PJC222 or PJC221 panel.
Se manual of the panel for more details.
If you have two thrusters bow and stern, then you need two 8730. One 8730B
for bow and one 8730S for stern. You can change instance of 8730 B & S with
a panel, see manual for panels for how to changing instance of 8730 B & S.
DO NOT connect any other control equipment to the S-link controlled products
except Side-Power original S-link products or via a Side-Power supplied interface
product made for interfacing with other controls. Any attempt to directly control or
at all connect into the S-link control system without the designated and approved
interface, will render all warranties and responsibilities for the complete line of
Side-Power products connected void and null.
We
Sleipner Motor AS
declare that these
control panels complies with health and
safety requirements according to the
Directive 89/336/EEC of 23 May 1989
amended by 92/31/EEC and 93/68/EEC.
