Attach Headboard
and Footboard
to Side Panels.
Attach Cross
Supports to
Aluminum Cleats.
(Use 4mm
Allen Wrench
to fasten all
Allen Bolts)
Use 25mm
Allen Bolts to
attach both
Cross Supports
to the Aluminum
Cleats.
Prepare Safety
Rail Hinge Pins
for Installation.
Factory preset has hinge pins that may be extended.
These pins need to be adjusted evenly on both
sides to fit properly when inserted into the posts.
NOTE: Full instructions for safety rail adjustment are found on page 10.
SleepSafe Bed (Low Bed) uses (8) 90mm Bolts
SleepSafe II (Medium Bed) uses (12) 90mm Bolts
Install
Safety Rails,
Bunkie Board,
or Box Spring,
then Mattress.
Insert the safety rail hinge
pins into both posts when
safety rail is in
the down
position.
CLOCKWISE
INCREASES play.
COUNTER-CLOCKWISE
DECREASES play.
Strike
Hinge Pin
5
Once installed, use both
hands to pivot the safety
rail up to attach it securely
to the posts.
Same rail installation
for both sides of the bed.
Aluminum
Cleat
Mattress
Box Spring,
or Bunkie Board
NOTE:
For Full and Queen size
beds, use provided bed slats for
installation between the
aluminum cleats.
Cross
Supports
Casters are pre-installed
