SleepSafe II Articulated
Assembly Instructions Continued...
STEP 3
Install the safety rails (#5) by inserting
the black hex bolt pivot pins into the
lower plastic strikes installed on each leg
as indicated by “A” in the diagram. The
rails can then be tilted up into the locked
position. The safety rails should be in-
stalled so that the “clean” side of the
rails face the occupant of the bed when
closed. (Screws will be visible from the
outside)
ALWAYS REMOVE AND INSTALL SAFETY RAILS WHILE THEY ARE IN THE
LOWERED POSITION
ALWAYS CHECK TO MAKE SURE THAT THE BRASS PINS ARE LOCKED IN
PLACE TO PREVENT THE SAFETY RAIL FROM OPENING UNINTENTIONALLY
NOTE CONCERNING BEDS WITH INSTALLED PADDING
If your bed was shipped with padding installed, you will note that it is attached using
Velcro to allow for easy removal for cleaning. If you remove the padding for any rea-
son, it is important that it be re-installed before the bed is occupied. The reason for this
is that, with the padding installed, there is virtually no space around the perimeter of the
mattress, greatly reducing the risk of entrapment. With any padding removed, however,
a space is created between the mattress and bed increasing the entrapment risk. Al-
ways keep the full padding installed, even if it is not required by the occupant of the
bed.
Conversion kits are available to install or remove padding.
