SLAYER ESPRESSO V3 USER MANUAL V5.1 | AUGUST, 2022
16
STEP 8:
TURN ON HEATING ELEMENTS
1.
Per step 7, ensure that both steam actuators are pulled forward, into
the “on” positions.
2.
Move the heating element breaker to the “on” position by flipping it to
the left.
3.
The machine is heated when steam begins to flow from the steam
wand; at this point, move the steam actuators into the “off” positions.
4.
Lift to remove cup tray and check the inside of the machine for leaks
or collected water.
5.
Allow Slayer to fully heat before use.
STEP 9:
ADJUST HOT WATER TEMPERATURE
PARTS AND TOOLS:
• Flat-head screwdriver
PROCEDURE:
1.
Remove the cup tray.
2.
Use a large, flathead screwdriver to remove the two top and one lower
rear screws from the x-leg, then carefully lift to remove the left rear
side panel.
• Take caution to not scratch the side panel during removal.
3.
Use the mix valve knob to regulate the amount of cold water that
mixes with the hot water.
• Turn counter-clockwise to increase the amount of cold water and
decrease the water temperature.
• Turn clockwise to decrease the amount of cold water and increase
the water temperature.
MIX VALVE
LOW PRESSURE INLET (BLUE)
