8
9
When the throttle or sensor is engaged (powering the motor), and the E-Bike is
in motion, the LED on the battery gauge (on the throttle or separate unit) indicate
instantaneous line voltage as measured at the battery terminals-not the available
energy in the available power in the battery pack.
The line voltage will wing out from a dead stop or going up a steep hill, the motor will
be under a high load and may show a reduced number of LED or show the “yellow”
or even “RED” LED.
When the throttle is disengaged (i.e. no power to the motor due to the bicycle being
stationary or coasting) LED on the throttle will indicate the battery pack’s voltage.
The voltage of the battery pack will rise when no load is on the motor. The best
indication of how much battery life is remaining is to check the throttle LED, after
reaching cruising speed, on a flat straight road. By doing this, the battery voltage
will stabilize and give a more accurate reading.
POWERING ON/OFF &
ENTERING SETTINGS
Picture 2
(ON/OFF)Press the Power button
for 3 seconds
Picture 1
I
: ON
O
: OFF
• Press the switch on the battery case (Picture 1).
• Press the power button on the LED display to activate the battery/controller system
(Picture 2).
• Press “
+
“ and ”
–
“ to increase or decrease the speed.
• Press and hold “
+
” for 2 seconds to turn on the front light, then press & hold for
another 2 seconds to turn off the front light.
• When powered on, press the power button to power off.
When powered off, the LED display monitor and the controller will no longer consume
power from the battery.
Press down on the thumb throttle slowly to avoid a sudden rush of speed forward.
The speed of the bike will increase as you press down on the thumb throttle. Release
the thumb throttle and apply the brakes to stop your bike. You will control the speed
of the bike by using both the thumb throttle and the brakes. When the brake handle is
activated it cuts power to the thumb throttle.
DO NOT USE PEDAL ASSIST AND THROTTLE AT THE SAME TIME.
PEDAL ASSIST SYSTEM (PAS)
THROTTLE
This E-Bike has an electric pedal-assisted driving system.
The pedal-assisted driving system consists of a driving unit, a battery, a controller,
and various electronic components (harness wires, sensors and switches).
It is essential to know that when the pedal assist system is on, the driving unit
provides power only while you are pedalling. The amount of power supplied by
the unit depends on your pedalling force and the assistance model/level you set with
the handlebar control unit at any time. When you stop pedalling, the pedal assist
system will disengage. In all models/levels, the pedal-assisted driving system reduces
progressively. It cuts off as the bike reaches 25KM/h (15.5MPH), or sooner if you stop
pedalling. The pedal-assisted driving system re-engages when speed drops below
25KM/H (15.5MPH) as long the pedals are turning.
