7
With the back panel removed you can remove the cable from the handheld. This
is done by sliding the cable/connector up toward the center of the handheld. This
will unlock the connector from the bezel as well as undo the spring loaded connec-
tion. Pull the cable straight out of the handheld bezel, note that the cable will have
positive charge if the vehicle ignition is on the “ON” position. Place the cable in a safe
location or protect it from touching any type of ground as this will cause damages to
the receiver. (see fig.10)
Reinstall the
cable into the
aluminum bezel
and align conn-
ector. Slightly
apply pressure to
compress the spri-
ngs on the 4-pin
connector and
slide the connector
down toward the bottom of the bezel. The connec-
tor will be held in place by the aluminum bezel and
will be locked into place once the back panel is re-
installed. (see fig.10)
** Do not cut handheld cable to shorten or
extend. If a custom length cable is needed
contact us at 559.348.9038 **
fig.10
fig.9
