ASSEMBLY
ASSEMBLY (PUTTING THE TRAMPOLINE AND ENCLOSURE TOGETHER)
IMPORTANT ASSEMBLY INFORMATION
• Need phillips screw driver (included with trampoline) and 2 adjus
table wrenches (for putting the trampoline together). A rubber
mallet is also recommended to make assembly easier.
•
Assembly requires two adults. Keep children away from the trampoline and enclosure until they are completely put together.
• Use gloves to protect your hands from pinch points during assemb
ly.
• Make sure that the trampoline is properly put togethe
r, with the frame pad correctly laid out, before you put together the trampoline
enclosure.
•
The assembly steps refer to parts by their descriptions and key numbers (see the PARTS LIST on page 13 and make sure that all
listed parts are included. If a part is missing, refer to ORDERING REPLACEMENT PARTS at the bottom of page 13.
TRAMPOLINE PLACEMENT
1. Place the trampoline and enclosure on a level surface before you use it.
2. Adequate overhead clearance is essential. A minimum of 24 feet (7.3 meters) from the ground is recommended. Provide clearance
from wires, tree limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline and enclosure
away from walls, structures, fences, and other play areas. Maintain a clear space on all sides of the trampoline and enclosure.
3. Use the trampoline in a well-lighted area. If the trampoline is indoors or in a shady areas you may need to use artificial (electrical)
lighting in the area.
4. Secure the trampoline and enclosure against unauthorized and unsupervised use.
5. Remove any objects from under the trampoline and enclosure.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
7. The trampoline enclosure is only to be used as an enclosure for a specific round trampoline.
Please locate tubing for steps 1 and 2 on page 14 and page15
1. Make sure that you understand the information in the box at the top of this page.
Lay one middle Tube (3) and two Frame Tubes (2) with four
square holes (A and B in the inset drawing) and two sockets
(17), one corner frame tube (1) on the ground in the position
shown. Make sure the Frame Tubes are turned so the small
holes (spring holes) are facing the ground.
NOTE: YOU ARE BUILDING THE TRAMPOLINE CORNERS
UPSIDE DOWN.
Secure the Leg Socket (17) to the frame tube (2) using two
M10X100 (13) bolts, two M10 washers (16) and two M10 nuts
(14). Don't tighten the nut yet. Repeat this step with another
socket. Insert one end of the frame Tube (2) with socket (17) into the
middle Tube (3), the other end is inserted into the corner frame
tube (1). Then attach another frame tube (2) with socket to the corner
frame tube. The frame Tubes with sockets should now appear as
shown in step 2 below.
Note: Make sure all pieces are completely inserted. Middle
Tube (3) is slightly bent. This is normal. The piece is not
damaged. Make sure that bend is to the outside.
The square enclosure
socket (2) should face out.
13
14
Trampoline Assembly
Summary of Contents for SWTCS13
Page 13: ...Key 13 ...
