15
2. Assemble Male curved Leg Brace (6) to the Female leg (5) before
assembling the rest of the legs. Secure Female leg (5) sections
with #8 screws (12).
Insert one end of the Leg Post (4) into the Leg Braces (5,6)
assembled above. Insert the other end of the Legs into the
Sockets. Make sure that the screw holes on the leg posts (4) are
facing inwards. Attach both legs to the Leg Braces (5,6) using
.t
e
y
s
w
e
r
c
s
e
h
t
n
e
t
h
g
it
t'
n
o
D
.)
2
1
(
s
w
e
r
c
s
8
#
d
e
d
u
l
c
n
i
e
h
t
Place one side of the assembled leg into the socket of the
trampoline frame. Have one person hold the attached leg. Pull
the assembled leg out and fit the other side of the straight leg
into the other socket. Securely tighten with #8 screws (12).
Tighten all the nuts and screws used in step 1 and 2. Then
place end caps (15) (shown in step 1) on the end of the bolts
that are not covered by the nuts.
Repeat steps 1 and 2 three additional times to assemble the other
Leg Straight
.
Tubes must
be assembled in correct
position as shown
Oval socket placed on
diagonal in line with
the trampoline frame
three leg sections.
3. Note: This step requires two persons . During this
step, you will connect the four assembled leg sections
Stand two leg sections and hold them in the positions
shown.. Insert the small end of the Top Tube into the
indicated Top Tube with Socket on the other leg section.
Repeat this step until all four leg sections are connected.
When this step is completed, the frame will be fully
assembled and freestanding.
4. Lay the Bed (Mat) (7) on the ground inside the assem-
bled frame. Make sure that the two warning decals (not
shown) are on top of the Bed (Mat). Enclosure net is up.
the enclosure net is pre-
installed on the Bed (Mat) (7) at the factory. Inspect the
attachments of the enclosure Netting to the trampoline
mat (bed). Make certain each of the V-rings on the tram-
poline mat (bed) is threaded through the corresponding
“buttonhole” in the Netting.
Note: There are 84 V-rings around the edge of the Bed
(Mat) (7) and 84 holes around the top of the frame. In
Steps 4 and 5 you will attach the Bed (Mat) (7) to the
frame, using 72 silver color springs (8) and 12 middle
gold color springs (9). 3 middle springs are positioned
at the center of each side. Go to step 5 to install springs.
Caution: It is wise to wear leather gloves while attach-
ing the Springs. Be careful where you place your
hands as the Springs and frame joints can pinch.
Note: Make sure to turn corners back over, so that the spring
holes on the main frame are facing up.
Insert one of the V-rings on the jump mat into one of the
"buttonhole" incisions on the bottom edge of the enclosure
mesh. Continue this process to the other V-rings one by one,
until all the V-rings are inserted though the
“buttonholes”
of the enclosure mesh.
Make certain that each of the V-
rings on the trampoline mat is threaded through the
corresponding 'buttonhole' in the enclosure netting,
and that the door opening of the enclosure is located near
the warning label of Jump mat.
Notice
if
Summary of Contents for SWTCS13
Page 13: ...Key 13 ...
