TROUBLESHOOTING
Should you encounter problems with your fireplace system, the problem may be with the fireplace itself or it could be
with the SKYTECH remote control. Review the fireplace manufacturer’s operation manual to make sure all connections
are properly made. Then check the operation of the SKYTECH remote in the following manner:
1.
Be sure the transmitter’s batteries are properly installed and that the battery output is 5.0 V or more.
2.
Check t
he
receiver
's batteries.
3.
Check to make sure the transmitter is communicating with the receiver.
• If the receiver beeps when the
[MODE]
button is depressed on the transmitter they are communicating.
• If the receiver does not beep when the
[MODE]
button is depressed on the transmitter, you will need to teach
the receiver the code of the transmitter as described in
STEP 4
.
4.
Make sure the transmitter is within the 15’-20’ range of the receiver.
5.
Positioning of the receiver is important. If the receiver is “enclosed” in a metal surround, the operation of the receiver
may be affected as noted below. Reposition the receiver to improve operating range. It is suggested that a heat shield
be
installed to protect the receiver from extreme heat. If the receiver is “enclosed” in a metal surround, this can:
• Cause the RF signal to get lost and not communicate with the receiver.
• Cause the working distance to be shorter than normal.
SPECIFICATIONS
BATTERIES: Transmitter 6V- 4 ea. AAA 1.5V, Alkaline
Remote Receiver
6V - 4 each AA 1.5V, Alkaline
FCC ID No.’s: transmitter – K9L5001; receiver – K9L1410RX
Operating Frequency: 303.8MHZ
Canadian IC ID No.’s: transmitter –2439A-5001; receiver – 2439A-1410RX
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
Summary of Contents for RC-AA-PROGR
Page 8: ......
