Page 5
O. FLAME MODE
This remote will operate the flame, allowing for (6) different flame height
levels. Press the MODE/SET button. The FLAME icon will appear on the
LCD screen. Press the FLAME icon on then screen, then ress
UP
or
DOWN
buttons to select desired flame level. Press the MODE/SET button to set or
wait 15 seconds and the control will automatically accept the new setting,
exit function setting mode and
LCD
display will return to normal view.
P. THERMO (THERMOSTATE) MODE
This remote feature allows you to thermostatically control the fireplace when hand held
remote is set to
THERMO
mode.
Set Temperature Range: 45˚F (7˚C) to 90˚F (32˚C).
Set remote to
THERMO
mode by pressing
MODE/SET
button twice.
"ON THERMO"
will appear on the LCD screen. Touch the SET TEMP ZONE on the screen, then press
the UP or DOWN ARROW buttons to the desired temperature. Within 5 seconds fireplace
will operate to that set temperature.
Set temperature will only appear when THERMOSTAT MODE is activated, but is
implemented in all MODES with the exception of MANUAL MODE.
To exit THERMO mode, press the MODE/SET button. This also shuts the fireplace
OFF.
IMPORTANT NOTE
When in THERMO mode the fireplace will not turn on until room temperature falls below SET TEMPERATURE.
IMPORTANT NOTE
The fireplace will initially light at the highest level. After 5 seconds the flame will adjust to last chosen level before fireplace was turned
OFF. This applies to MANUAL and THERMO modes
.
IMPORTANT NOTE
The flame height can adjust up to (6) different height levels according to amount of heat required. This range however is dictated by the
Flame Level setting (see previous page). When desired temperature is met, the fireplace will shut off until more heat is required.
Figure 17O
Figure 17P
17 - REMOTE RECEIVER INFORMATION
