REV 8-14-17 Page 8
Skytech: 3002P
PROGRAM OPERATION OF THE TRANSMITTER
The transmitter has a built-in factory program, (7) days a week
with (4) continuous time periods for each day. Each time period
has it’s own starting time and temperature. A chart of the built-
in programs is at the right.
NOTE
: The ending time for one
period is the starting time for the next period.
You may change any of the factory settings by following the
procedures below. Should you desire to return to the factory
program, follow the procedures under heading
PROGRAM
REVIEW
or
PROGRAM CANCELLATION.
PROGRAMMING THE TRANSMITTER TO YOUR CUSTOM SETTINGS
The transmitter built-in program is exactly the same for everyday of the week. If desired, you may change a single day
or all seven (7) days of the built-in program. Use the blank table on the next page and fill in your customized settings. To
change one or all seven days open the transmitter front cover and complete the following steps:
STEP 1
: Press the PROG button for 4 seconds and release.
The words
START
and
For
will begin to blink (Fig. 20). The
current DAY, PERIOD, TIME and SET temperature of the built-in
factory program will also be displayed.
To program the
DAY
and
PERIOD OF DAY
, press the AHEAD
or BACK buttons to display the DAY and PERIOD you wish to
program. When you have reached the correct DAY and PERIOD
OF DAY push the PROG button and the
TIME
will blink on the
LCD screen (Fig. 21).
Built -in
Factory
Program
Period
Time/Temp
ON
Time
OFF
All 7 Days
Morn
6:00AM / 70° 8:30AM
Day
8:30AM / 60° 3:00PM
Eve
3:00PM / 70° 11:00PM
Night
11:00PM / 63° 6:00AM
Fig. 19 Built-in Factory Program
Fig. 20 Setting Day and Period of Day
BUILT-IN PROGRAM
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
COMMUNICATION – SAFETY – TRANSMITTER – (C/S – TX)
This SKYTECH series remote controls have a COMMUNICATION – SAFETY function built into the software. It provides
an extra margin of safety when the TRANSMITTER is out of the normal 20-foot operating range of the receiver.
The COMMUNICATION – SAFETY feature operates in the following manner for all OPERATING MODES: ON/THERMO/
PROGRAM.
At all times and in all OPERATING MODES, the transmitter sends an RF signal every fifteen (15) minutes, to the receiver,
indicating that the transmitter is within the normal operating range of 20-feet. Should the receiver NOT receive a transmit-
ter signal every 15 minutes, the IC software, in the RECEIVER will begin a 2-HOUR (120-minute) countdown timing func-
tion. If during this 2-hour period, the receiver does not receive a signal from the transmitter, the receiver will shut down
the fireplace being controlled by the receiver. The RECEIVER will then emit a series of rapid “beeps” for a period of 10
seconds. Then after 10 seconds of rapid beeping, the RECEIVER will continue to emit a single “beep” every 4 seconds
until a transmitter signal is again received. The intermittent 4 second beeping will go on for as long as the receiver’s bat-
teries last which could be in excess of one year.
To “reset” the RECEIVER and operate the fireplace system, you must press the MODE button on the transmitter. The
word ON must display on the LCD screen. By turning the system to ON, the COMMUNICATION SAFETY operation is
overridden and the system will return to normal operation depending on the MODE selected at the transmitter.
The COMMUNICATION SAFETY feature will reactivate should the transmitter be taken out of the normal operating range
or should the transmitter’s batteries fail or be removed.
GENERAL INFORMATION
