21
SP9600 User
Manual
5.4
Set Position Report Interval To User
Command:
USP command is to set mode0(static mode) and mode1(dynamic mode) report interval
to user0 and user1.
Command format:
1.Set position report interval to user0:
<User Password>,USP0; <Mode>;<Interval>;<Report mode>;<Data format>
2.Set position report interval to user1:
<User Password>,USP1; <Mode>;<Interval>;<Report mode>;<Data format>
Parameter description:
<Mode>:
“0”: Report mode0, It‟s called static mode.
“1”: Report mode1, It‟s called dynamic mode. This is valid only when command DNU is
enabled.
<Interval>:
Report interval, range is “30 to 900 seconds”, “15 to 59 minutes”, “1 to 720 hours”. The
parameter unit definition is as follows:
S: Second M: Minute H: Hour
<Report mode>:
“O”: Disable
“G”: GPS information prior, otherwise use GSM tower position instead, GSM tower
uses HEX format.
“L”: Periodical voice call (Voice monitoring).
<Data format>:
“O”: Device will not generate data.
“T”: Text.
“W”: Map hyper link.
Example:
Set User0 static report interval:
1234,USP0;0;1H;G;W
Disable User0 static report interval:
1234,USP0;1;24H;O;W
