Important
When placing or withdrawing the Bowl be sure the motor has stopped .
3.1 Starting
...overload the motor with big or heavy portions as it will make the blender´s life shorter. if
motor stops, turn it off immediately, unplug and remove part of the load before start
operating again.
3 . Operation
Observation
The necessary processing time will be different for each kind of
IMPORTANT
NEVER SWITCH ON THE MACHINE BEFORE LOADING ITS
BOWL , BECAUSE IRREPARABLE DAMAGE WILL RESULT .
3.2 How to Feed the Blender
The TA-04 GOURMET Blenders are machines working at high speed (
approximately 38.000 rpm off load ) .
To feed it observe the following instructions :
Cut the product in small pieces , about 1.5 inches wide , such precaution helps
to decrease the blending time process , mainly when working with frozen products . When
working with ice it is recommended to join a little water .
Withdraw the Lid No.01 (Pic.01) .
Place the product inside the Bowl No.02 (Pic.01) .
Close the Bowl with the Lid , and Switch ON the machine .
06
03
Before to switch the blender ON , adjust the desired speed using the speed
control knob No. 08 (Pic 01) . Not knowing the best speed to be used, use then the
maximum speed .
Minimum speed is 12,000 rpm and maximum speed is 38,000 rpm.
After to adjust the speed turn ON the blender using the ON/OFF Switch No.
06 ( Pic 01 ) .
Pulse Switch on the right side of the motor housing strots the blender amd
will keep it running as long as it is pressed.
4.1.2 Warnings
The Switch ON/OFF position must be well known , to allow to be used
without to look for it .
Before to proceed to any maintenance , unplug the machine from the
electric network .
Provide enough space around the machine to avoid falls .
Water and oil may produce a dangerous and slippery floor . To avoid
accidents the floor shall be dry and clean .
Never use a manual command ( button , switch , lever , etc ) unadvisedly .
If any work has to be done by more than one person , coordination signs
shall be accorded , for each step of the work . Next step shall not be started without the sign
is given and acknowledged .
4.1.3 Advices
Be sure this Manual INSTRUCTION has been fully understood . Each
function or operation procedure has to be perfectly clear .
Any manual command ( button , pulses , electric switch , lever, etc ) shall be
given only after to be sure it is the correct command .
If an electric supply failure happens , the machine shall immediately be
switched OFF .
Avoid any strikes on the machine , since they could produce failures or a
bad performance .
Avoid water, dust or dirt to get inside the electrical or mechanical
components of the machine .
DO NOT CHANGE the machine original characteristics .
DO NOT TEAR, WITHDRAW OR GET DIRTY , ANY SAFETY OR
IDENTIFICATION LABEL . If a Label is lost or unreadable ask for a new one to your Dealer .
4.2 Cares before to start the Blender
IMPORTANT
Read carefully this INSTRUCTION before to start the machine . Be sure it has
been correctly understood . If any doubt arises contact the department Chief
or the Dealer .
4.2.1 Danger
Electric wires must have a perfect insulation, any damage may cause an electric
shock .
Before to use them be sure they are in good conditions .
4.1.1 Dangers
Some parts of the machine electrical commands have high voltage
points or terminals . These when touched , may produce severe electric shocks , and
even DEATH .
Never touch a manual command ( button , electric switch, etc ) with wet
hands , shoes or clothes. If this warning is not followed electric shocks and even
DEATH , may occur .
4.1 Basic Operation Procedures