Before to start be sure the Blender is perfectly steady . It is recommended to
work with the machine placed on a 850 mm high table .
Before to use it , the parts to be in contact with the product to be processed shall
be washed with water and soap . To clean your TA-04 read item No. 3.3 Cleaning Pg 03 .
You should not...
… expect your blender to replace any other kitchen appliance. It is not supposed to make
mashed potatoes, it does not blend egg white or any other cream for covering, it does not
grind raw meat, it does not blend hard pastas and not extract pulp from fruits and
vegetables.
…process blending for too long. Remember that the blender works in seconds and not in
minutes. Therefore, never let your blender working for more than one minute. It is better no
turn it off and check the mixing consistency after a few seconds to avoid too much blending.
02
1.3 Technical Characteristics
Tabela - 01
2.1 Installation
To achieve a good performance the TA-04 GOURMET Blender shall be
installed on a steady and flat surface about 850 mm above the floor .
The TA 04 Blender has been designed for 110 V (60 c/s) or 220 V (50 c/s or
60c/s ) voltages . Check the voltage , to be sure the electric source has the same voltage
indicated on the label placed on the cord .
The cord plug has two round pins. It is mandatory to have the cord plugged
into the socket before to Switch ON the machine .
2. Installation and Pre-operation
2.2 Pre-Operation
Important
When placing the Bowl No. 02 ( Pic. 01) , check if it is well fitted . The fitting
system assures the Bowl to be steady in eight positions , therefore giving a
perfect performance guaranty .
110 or 220 *
50 / 60
1650
1,65
550
230
200
4,1
Voltage
Frequency
Power Rating
Consumption
Height
Width
Length
Net weight
Gross weight
[V]
[ c/s ]
[w]
[kw/h]
[mm]
[mm]
[mm]
[kg]
[kg]
4,7
07
Cup maximum capacity
Rotation
[l]
[ rpm]
4
38000
(*) Voltage will be only the one indicated on motor characteristics label.
Watch out any abnormal noises coming from the motor or any moving parts .
Check the safety devices to be normally operating .
4.3 Routine Inspection
4.2.2 Advices
The instructions of the this Manual shall be perfectly understood .
All function or procedure shall be perfectly clear .
Any manual ( button , pulse ,electric switch or lever ) command shall be
given only after to have the complete assurance it is the right command .
4.2.3 Cares
The electric cord , used to feed the electricity to the machine must have the
right section to be able to support the machine motor power rating . Any electric wiring
running over the floor near the machine shall be duly protected to avoid short circuits .
4.4 Operation
4.4.1 Warnings
Long hairs , that could touch the machine , could cause serious accidents .
Tie them or cover them with a head scarf .
Only skilled operators shall use the machine .
NEVER use the machine without any of its safety devices normally
operating.
4.5 After work end
4.5.1 Cares
Always clean the machine . Before to clean it ALWYS UNPLUG IT FROM THE SOCKET .
Never start to clean before the motor is COMPLETELY STILL .
Be sure all the machine components are in their due places before to start to work again .
4.6 Maintenance
4.6.1Dangers
With the machine switched ON any maintenance operation is dangerous .
UNPLUG THE MACHINE FROM ITS SOCKET DURING THE WHOLE MAINTENANCE
OPERATION TIME .
IMPORTANT
Always unplug the machine during emergencies .