02
1. INTRODUCTION
1.1
Safety
If and when the Food Processor Model PAIE is not correctly used, it is
potentially a DANGEROUS machine. Never place your hand inside the product outlet ,
nor inside the throats . Only duly trained people shall change the Discs or Grilles , shall
clean or perform any other maintenance service. To avoid ACCIDENTS follow the
instructions below:
1.1.1 Handle the Discs and grilles carefully, because they have sharp knives .
1.1.2
Take the electric plug off its socket, before to withdraw any moving part,
change the discs or grilles, or before cleaning or any other maintenance operation.
1.1.3
Never use any kind of tools , to introduce the food inside the throats ,
other than the pushers provided with the Food Processor .
1.1.4
Never open the frame lid , before to be sure the disc are completely still
1.1.5
Never throw water directly to the machine
IMPORTANT
This equipment shall not be used by persons ( including children) having mental or
physical reduced capabilities , or insufficient experience or knowledge, unless they
did receive sufficient instructions or supervision regarding its use, given by a
person responsible for the equipment security .
IMPORTANT
If the cord is not in suitable conditions for use, it shall be changed by the
manufacturer, its Authorized Technical Assistant , or by a qualified person , in order
to avoid accidents .
1.2 MAIN COMPONENTS
The Food Processor Model PAIE is fitted with two safety sensors . When the
Ram Feed Arm is lifted , the machine stops automatically , and will start again when the
Arm is lowered .
23
5.2.3 Removing the Motor Housing
a)
remove the frame lid ( 10308.0) and any disc assembled on the
machine , to do so follow the instructions at item 3.4 .
b)
Place the machine had down, and remove the four feet (03086.4) ,
unscrewing them manually . Remove them with the protection plate(08826.9).
c)
With the help of a screwdriver, partially loose the two screws (01639.0)
placed behind the electric motor (A) , that fix the motor housing (08708.4). Then
remove completely the other four screws (01639.0) that fix the motor housing (08708.4)
d)
Move the motor housing (08708.4) towards the cord side until it gets
out of the two screws that were initially partially loosen . The motor housing will be
removed .
5.2.4 Belts
To achieve a good performance of the machine and to have a long life belt, the
belt must be perfectly adjusted . If the belts are loosen they will slide during operation.
As well as, care must be taken not to tight the belt too much because it will prematurely
wear the bearings .
To adjust the belt , after having removed the motor housing (08708.4) , item
5.2.3 , using a 13 mm spanner, loose the two screws (03793.1) fixing the electric motor
(A) , then using a large screwdriver , press the electric motor to tight the belt , and tight
again the two screws .
5.2.5 Safety Sensor
To adjust the Ram Feed Arm safety device , open the frame lid , and using a
7mm spanner loose the M4 nut (09205.3). With the help of a 1.5 mm allen key adjust
the allen screw M4 (10193.1) until the push button (08698.3) inside the machine acts.
Summary of Contents for PAIE
Page 2: ......
