04
3. Operation
3.1 Starting
Before to use the equipment all the parts to be in contact with the product shall be
washed with water and neutral soap ( see item 3.3 Cleaning )
Make sure the equipment is stable on the working surface
IMPORTANT
When it is desired to remove or to place the cup # 02 (Pic,01) make sure the motor
is completely still , avoiding a premature wear of the coupling.
The blender is started by means of the ON/OFF Switch # 07 (Pic.01) placed on
the housing # 05 (Pic.01).
3.2 Operation Procedures
The blenders works at high speed ( about 3500 rpm). To load them follow the below
procedure :
Remove the Lid # 01 (Pic.01)
With the Blender switched OFF introduce the product inside the Cup # 02 (Pic.01)
Replace the Lid # 01 (Pic.01) .
IMPORTANT
The processing time changes for each product . Solid products should not be
processed without a liquid , because overheating may occur and therefore damage
the Cup seal
IMPORTANT
Do never switch ON the blender empty, because irreparable damage will occur .
IMPORTANT
Never clean the machine when it is connected to the power point,
always unplug the machine before cleaning. Before to remove the
Cup make sure the motor is completely still. When cleaning the Cup
inside be careful with the knife
3.3 Cleaning
Tabla - 02
5.2 Diagrama Eléctrico
Motor
110 ou 220
Volts
Problemas
Causas
Soluções
* Falta de Energia
eléctrica, o enchupe
desconectado de la red
eléctrica.
* Problema en el circuito
e l é c t r i c o i n t e r n o o
externo de la máquina.
* Verifique si el
e n c h u f e e s t á
conectado la toma de
corriente y si hay
energía eléctrica en la
red eléctrica.
* La Máquina no se
prende.
* Va s o p r e s e n t a
filtracion.
* Capacitorde arranque
defectuoso.
* Llame el servicio
técnico.
* Problema en el sistema
de vedamiento.
* Llame el servicio
técnico.
* Llame el servicio
técnico.
Llave Prender/Desligar
*La maquina se prende
pero el motor gira
despacio.
19