Skymsen CSE, Instruction Manual

Page: 18 / 44

18
TABLE 04
PROBLEM CAUSES SOLUTIONS
The equipment does not
switch ON.
Wrong starting procedure.
Motor thermal protection
turned ON.
Electricity shortage.
Problem with the electric circuit.
Read item 3.1 Starting.
Wait some minutes and try
again.
Check network.
Call Technical Assistance.
The equipment stops or slows
down when processing the
product.
The belt is sliding.
The safety device on the lid
contact is failing.
Problem with the electric motor.
Adjust the belt tension.
Call Technical Assistance.
The processed product
remains inside the equipment.
The expeller dish is missing.
Off load throat obstructed.
Place the dish.
Clean the throat.
Irregular cut.
Blunt blades or damaged
blades.
Change the plate.
Burnt smell or smoke. Problem with the electric circuit. Call Technical Assistance.
Damaged cord.
Problems with equipment
transportation.
Call Technical Assistance.
Abnormal noises. Problem with the bearings. Call Technical Assistance.