Merlin 2003 DV and MPEG-2 Recorder and Dual Stream Decoder
Page 11
7.
Remove the Merlin 2003 board from its protective wrapper and orient the board as shown:
8.
Holding the board by the top two corners, carefully slide the board into the desired slot and press on
the top edge of the board until it is firmly seated. If the board does not seat correctly, do not apply
excessive force. If necessary pull the board out and try installing it again.
9.
Tighten the screw over the slot cover to hold the Merlin board in place.
10.
Replace the cover and tighten any screws needed to hold the cover in place.
11.
Reconnect cables.
12.
Connect the 15 pin and 9 pin cable that came in the box with the Merlin board.
13.
Connect an Output monitor to one of the video output cable.
14.
Connect an input video source to one of the video input cables.
15.
Connect input and output audio to the Red and White audio cables.
Merlin 2003 Board
