53
9. Installation/Settings
39740
The selection INSTALLATION contains the following 6 submenus:
- Antenna Configuration
- Programme Search
- System Setting
- Parental Control
- Factory Setting
- Software Upgrade
Antenna Configuration
Pay attention to the lower part of the on-screen image during antenna selection.
Press the coloured buttons to obtain the following possibilities:
Red:
Ant. help, for calculating the elevation angle and angle of direction for fixed
satellite antennas
Green: DiSEqC 1.2-rotor or fixed satellite antenna
Yellow: For USALS rotors, for automatic calculation of each SAT position
Blue:
Opens the programme search menu
9.1 Antenna Configuration DiSEqC 1.2 (Rotor Control)
If you do not have a DiSEqC 1.2-rotor, please proceed to the next section and read
“Fixed Antenna Configuration” on the next page.
When setting the DiSEqC-rotor, press the green button to obtain the menu on the
left.
1) Antenna: Carry out up to 16 different antenna configurations in connection with
various SAT change-over switches.
2) Satellite: Select the satellite to be received.
3) LNB: Digital LNBs are now a standard feature. If you are using an older or exotic
LNB, enter the changes manually. Only change the values if you are familiar
with the LNB technical data!
4) LNB info: Display of LNB frequencies (lower and upper oscillator frequency of
the LNB). The values for commercially available Digital LNBs are 9750
(oscfreq. LNB1) and 10600 (oscfreq. LNB2). Only change these values if the
assembly instructions for the satellite system clearly demand it!
5) SAT switch 0/12 volt and 22 kHz: Here it is possible to set which change-over
switch and switching pulse is to be used to receive various satellites. 0/12 volt
and 22 kHz change-over switches no longer figure in digital reception systems!
To prevent malfunctioning, set the settings for both types of change-over switch
to “No”.
6) SAT switch DiSEqC: Use a 2-way or 4-way DiSEqC switch, set here via which
input of the DiSEqC switch you wish to receive the satellite. The inputs of the
DiSEqC change-over switch are marked accordingly (1, 2, 3, 4 or A, B ...).
7) C/Ku-band: To prevent malfunctioning, leave the “No” setting. The C-band is
mainly received in the Middle East or Russia.
