-
During the Arm Away mode, you will have 30 seconds to leave the premises, this is
called the exit delay. When the exit delay expires, the Wireless External Alarm is armed.
-
If a sensor is triggered while the Wireless External Alarm is armed, such as entering the
premises, an entry delay will be triggered. User is allowed to disarm the Wireless
External Alarm during the 30 seconds entry delay. You will hear beeping every 5
seconds during the entry delay interval. The beeping rate will change from slow to fast in
last few seconds. If the Wireless External Alarm is not disarmed within 30 seconds,
alarm will sound immediately.
7. Operating the Skylink Security Control Panel
The Wireless External Alarm is designed to work with the Skylink security control panel such as
AM-001, ML-001 and SC-001. Put the control panel that you plan to program into programming
mode. Refer to the User’s Instructions of that control panel.
7A – Learn control panel AM-001 or ML-001 to the Wireless External Alarm:
-
Press and hold the Learn button on the Wireless External Alarm for 2 seconds and then
release. The Learn/Set LED will flash.
-
Activate the control panel AM-001 or ML-001 by pressing [ARM] and then enter your
current Master PIN (MPIN) [factory default 1 2 3 4].
-
You will hear 2 beeps and the LEDs will flash twice indicating the control panel is now
programmed to the Wireless External Alarm.
7B – Learn control panel SC-001 to the Wireless External Alarm:
-
Press and hold the Learn button on the Wireless External Alarm for 2 seconds and then
release. The Learn/Set LED will flash.
-
Activate the control panel SC-001 by entering your current Master PIN (MPIN) [factory
default 0 0 0], then enter [B], [B].
-
You will hear 2 beeps and the LEDs will flash twice indicating the control panel is now
programmed to the Wireless External Alarm.
