SJ 86T
December 2007
Page 35
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the MEWP.
F
AMILIARIZA
TION
• Test Off/Base/Platform Switch
1. Ensure both “
” emergency stop
buttons are pulled out.
2. Start engine.
3. On base control console, turn off/base/
platform key switch to “
” off position.
Result:
Engine should shut down and
MEWP functions should not operate.
4. On base control console, turn off/base/
platform key switch to “
” platform
position.
WARNING
Ensure that you maintain three points
of contact to mount/dismount platform.
5. Enter platform and close gate/drop bar.
6. Select “
” start position from engine
start/on/off switch until engine starts.
7. Dismount from platform.
8. On base control console, attempt to
activate each boom and platform switch
while holding start/function enable/
emergency power switch in function
enable position.
Result:
All boom and platform functions
should not operate while holding start/
function enable/emergency power switch
in function enable position.
9. Push in “
” emergency stop button to
turn engine off.
10. Pull out “
” emergency stop button.
2.4-3 Platform Control Console
WARNING
Ensure that you maintain three points of
contact to mount/dismount platform.
1.
On base control console, turn off/base/platform
key switch to “
” platform position.
2.
Enter platform and close gate/drop bar.
Platform Control
Console
Drive/Steer
Controller
Fall Protection
Anchorage
Fall Protection
Anchorage
Emergency Stop
Footswitch
Section 2 - Familiarization
Function Tests
