SkyAzúl MicroGuard 534, Operator'S Manual, Page: 13 / 24

Figure 1−76
Erected Attachment Offset Selection
20
40
6. If an offset fly was previously selected, the erected
attachment selection screen will change and
graphically display the available offset angles.
Press the corresponding configuration selection
button to select the installed offset angle if re-
quired.
Figure 1−77
Rear Winch Lifting Point Selection
7. The erected attachment or erected attachment off-
set selection screen will change and graphically
display the rear winch lifting point. Press the corre-
sponding configuration selection button to select
the actual rear winch lifting point. Or press the cor-
responding configuration selection button to se-
lect the rear winch not in use.
Figure 1−78
Front Winch Lifting Point Selection
8. If the crane is equipped with a front winch, the rear
winch lifting point screen will change and graphical-
ly display the front winch lifting point. Press the cor-
responding configuration selection button to select
the actual front winch lifting point. Or press the cor-
responding configuration selection button to select
the front winch not in use.
Figure 1−79
Stowed Attachment Selection
24.5’
36.5’
61’
9. If the crane is equipped with a fly and was not se-
lected as an erected attachment, the winch lifting
point screen will change and graphically display
the stowed attachment. Press the corresponding
configuration selection button to select the actual
stowed attachment if required.
MicroGuard 534 Operator's Manual
SkyAzúl, Equipment Solutions
www.skyazul.com
7
301-371-6126